Person: Ruhl, Aki Sebastian
Lade...
E-Mail-Adresse
Geburtsdatum
Forschungsvorhaben
Organisationseinheiten
Berufsbeschreibung
Nachname
Ruhl
Vorname
Aki Sebastian
Name
13 Ergebnisse
Suchergebnisse
Gerade angezeigt 1 - 10 von 13
Veröffentlichung Fast empirical lab method for performance projections of large-scale powdered activated carbon re-circulation plants(2019) Zietzschmann, Frederik; Dittmar, Stefan; Ruhl, Aki SebastianPowdered activated carbon (PAC) for organic micro-pollutant (OMP) removal can be applied effectively on wastewater treatment plant (WWTP) effluents by using recirculation schemes, accumulating the PAC in the system. This technique is complex because several factors are unknown: (i) the PAC concentration in the system, (ii) specific and average contact times of PAC particles, and (iii) PAC particle loadings with target compounds/competing water constituents. Thus, performance projections (e.g. in the lab) are very challenging. We sampled large-scale PAC plants with PAC sludge recirculation on eight different WWTPs. The PAC plant-induced OMP removals were notably different, even when considering PAC concentrations in proportion to background organic sum parameters. The variability is likely caused by differing PAC products, varying water composition, differently effective plant/recirculation operation, and variable biodegradation. Plant PAC samples and parts of the PAC plant influent samples were used in laboratory tests, applying multiples (0.5, 1, 2, 4) of the respective large-scale "fresh" PAC doses, and several fixed contact times (0.5, 1, 2, 4, 48 h). The aim was to empirically identify suitable combinations of lab PAC dose (as multiples of the plant PAC dose) and contact time, which represent the PAC plant performances in removing OMPs (for specific OMPs at single locations, and for averages of different OMPs at all locations). E.g., for five well adsorbing, little biodegradable OMPs, plant performances can be projected by using a lab PAC dose of twice the respective full-scale PAC dose and 4 h lab contact time (standard deviation of 13 %-points). © 2018 Elsevier Ltd. All rights reserved.Veröffentlichung Comparing fine particulate iron hydroxide adsorbents for the removal of phosphate in a hybrid adsorption/ultrafiltration system(2019) Hilbrandt, Inga; Shemer, Hilla; Ruhl, Aki SebastianThe use of micro-sized iron hydroxide adsorbents in mixed reactors is a promising technique for the removal of inorganic contaminants from wastewater within minutes of contact time. This study focusses on phosphate adsorption onto fine fraction granular ferric hydroxide (nGFH) and iron oxy(hydr)oxide agglomerates (IOAs) in a reactor with submerged ultrafiltration (UF) membrane. The performance of the hybrid adsorption/UF membrane system was evaluated for various adsorbents and phosphate concentrations, residence times and concentrations of co-existing ions. The membrane was not fouled at the experimental conditions used (up to 6.3 g/L adsorbent). Phosphate loadings of 20 and 60 mg P/g Fe (36.1 and 108.3 mol P/mol Fe) were reached for nGFH and IOAs, respectively (C0(P) = 4.5 mg/L, deionized water at pH 8, C(Fe) = 0.6 g/L). A shortened residence time of 15 min in the reactor led to a decrease in final loading of 6 mg/g compared to 30 min residence time (54 mg/g compared to 60 mg/g). An extension to 60 min did not result in higher loadings. An increase in adsorbent (IOA) concentration from 0.1 to 0.3 mg/L resulted in an increase of phosphate removal (27 to 35%). Simultaneously, loadings decreased from 50 to 35 mg/g. The application of the developed process for the treatment of artificial secondary effluent resulted in an increase of 87 and 60% in treated volumes until breakthrough (50%) for nGFH and IOAs, respectively, compared to deionized water. Thus, the combined process of adsorption and particle separation using a submerged membrane can be well adjusted according to water composition, initial pollutant concentrations and desired removals. © 2019 Elsevier B.V. All rights reserved.Veröffentlichung Simulating effluent organic matter competition in micropollutant adsorption onto activated carbon using a surrogate competitor(2018) Dittmar, Stefan; Zietzschmann, Frederik; Mai, Maike; Ruhl, Aki SebastianAdsorption onto activated carbon is a promising option for removing organic micropollutants (OMPs) from wastewater treatment plant (WWTP) effluents. The heterogeneity of activated carbons and adsorption competition between OMPs and adsorbable compounds of the effluent organic matter (EfOM) complicate the prediction of OMP removals. Thus, reliable and simple test systems are desirable. For this study, batch experiments with powdered activated carbon (PAC) were carried out to examine methyl orange (MO) as a selected surrogate competitor to simulate EfOM adsorption competition. MO solutions were spiked with carbamazepine (CBZ) as an indicator substance for well-adsorbing OMPs. On the basis of CBZ adsorption isotherms in WWTP effluents, MO concentrations for batch test solutions with identical adsorption competition toward CBZ were calculated. The calculations were performed according to an empirical model of CBZ adsorption in the presence of MO, since predictions employing the ideal adsorbed solution theory (IAST) proved to be inaccurate. Comparative batch tests with five different PACs were conducted with WWTP effluent and respective MO batch test solutions. Except for one PAC, the achieved CBZ removals were very similar in WWTP effluent and the test solution. Additionally, a universal correlation between MO and CBZ removals was found for four PACs. Quelle: https://pubs.acs.org/Veröffentlichung Tire and road wear particles in road environment - Quantification and assessment of particle dynamics by Zn determination after density separation(2019) Reemtsma, Thorsten; Klöckner, Philipp; Eisentraut, Paul; Ruhl, Aki SebastianIn this study, a method for the determination of tire and road wear particle (TRWP) contents in particulate samples from road environment was developed. Zn was identified as the most suitable elemental marker for TRWP, due to its high concentration in tire tread and the possibility of separation from other Zn sources. The mean concentration of 21 tire samples was 8.7 +/- 2.0 mg Zn/g. Before quantification in samples from road environment, TRWP were separated from the particulate matrix by density separation. Method development was conducted using shredded tread particles (TP) as a surrogate for TRWP. Recovery of TP from spiked sediment was 95 +/- 17% in a concentration range of 2 - 200 mg TP/g. TP determination was not affected by other Zn containing solids or spiked Zn-salts. By adjusting the density of the separation solution to 1.9 g/cm3, more than 90% of total TRWP were separated from the sample matrix. TRWP concentrations in particulate matter collected in two road runoff treatment systems ranged from 0.38 to 150 mg TRWP/g. Differences in quantified TRWP contents of the two systems indicate changes in particle dynamics due to ageing and aggregation processes. The developed method allows TRWP determination in road runoff and in environments that are influenced by road traffic. The validated separation procedure can also be applied for TRWP characterization in future studies. © 2019 Elsevier Ltd. All rights reserved.Veröffentlichung Quantification and isotherm modelling of competitive phosphate and silicate adsorption onto micro-sized granular ferric hydroxide(2019) Hilbrandt, Inga; Lehmann, Vito; Zietzschmann, Frederik; Ruhl, Aki SebastianAdsorption onto ferric hydroxide is a known method to reach very low residual phosphate concentrations. Silicate is omnipresent in surface and industrial waters and reduces the adsorption capacity of ferric hydroxides. The present article focusses on the influences of silicate concentration and contact time on the adsorption of phosphate to a micro-sized iron hydroxide adsorbent (nGFH) and fits adsorption data to multi-component adsorption isotherms. In Berlin drinking water (DOC of approx. 4 mg L-1) at pH 7.0, loadings of 24 mg g-1 P (with 3 mg L-1 initial PO43--P) and 17 mg L-1 Si (with 9 mg L-1 initial Si) were reached. In deionized water, phosphate shows a high percentage of reversible bonds to nGFH while silicate adsorption is not reversible probably due to polymerization. Depending on the initial silicate concentration, phosphate loadings are reduced by 27, 33 and 47% (for equilibrium concentrations of 1.5 mg L-1) for 9, 14 and 22 mg L-1 Si respectively. Out of eight tested multi-component adsorption models, the Extended Freundlich Model Isotherm (EFMI) describes the simultaneous adsorption of phosphate and silicate best. Thus, providing the means to predict and control phosphate removal. Longer contact times of the adsorbent with silicate prior to addition of phosphate reduce phosphate adsorption significantly. Compared to 7 days of contact with silicate (c0 = 10 mg L-1) prior to phosphate (c0 = 3 mg L-1) addition, 28 and 56 days reduce the nGFH capacity for phosphate by 21 and 43%, respectively. Quelle: https://pubs.rsc.orgVeröffentlichung Relevance of nano- and microplastics for freshwater ecosystems: A critical review(2019) Triebskorn, Rita; Braunbeck, Thomas; Grummt, Tamara; Ruhl, Aki SebastianThe current paper critically reviews the state-of-the-science on (1) microplastics (MP) types and particle concentrations in freshwater ecosystems, (2) MP and nanoplastics (NP) uptake and tissue translocation, (3) MP/NP-induced effects in freshwater organisms, and (4) capabilities of MP/NP to modulate the toxicity of environmental chemicals. The reviewed literature as well as new data on MP and NP concentrations in the river Elbe and on particle uptake into human cells indicate an environmental relevance of small particles in the low nano- and micrometer range higher than that of larger MP. © 2018 Elsevier B.V. All rights reserved.Veröffentlichung Conditioning fixed-bed filters with fine fractions of granulated iron hydroxide (MyGFH)(2018) Hilbrandt, Inga; Jekel, Martin; Ruhl, Aki SebastianThe fine fraction of granular ferric hydroxide (MyGFH, < 0.3 mm) is a promising adsorbent for the removal of heavy metals and phosphate, but properties of MyGFH were hitherto not known. The present study aimed at characterizing MyGFH regarding its physical and chemical properties and at evaluating methods for the conditioning of fixed-bed filters in order to develop a process that combines filtration and adsorption. Conditioning was done at different pH levels and for different particle sizes. Anthracite, coke, pumice and sand were studied as potential carrier materials. A method for the evaluation of the homogeneity of the iron hydroxide particle distribution on pumice filter grains using picture analysis was developed. Pre-washed pumice (pH 8.5) proved to lead to high embedment and a homogeneous distribution of MyGFH. Filter runs with phosphate (2 mg/L P) showed similar breakthrough curves for the embedded fine fraction adsorbent and for conventional GFH. © 2018 by the authors.Veröffentlichung Fate of leaf litter deposits and impacts on oxygen availability in bank filtration column studies(2018) Bayarsaikhan, Uranchimeg; Filter, Josefine; Gernert, Ulrich; Ruhl, Aki SebastianDegradation of particulate organic carbon (POC) such as leaf litter might deplete dissolved oxygen within the upper layers of bank filtration, an efficient and robust barrier for pathogens and for various organic micro-pollutants (OMP) in water supply systems worldwide. The degradation of OMP during bank filtration depends on the redox conditions. The present study aimed at identifying the impacts and fates of different local leaves on the oxygen consumption and the possible biological degradation of indicator OMP. Oxygen concentrations initially decreased within the columns from around 8 mg/L in the influent to low concentrations indicating extensive consumption within a short travel distance. Still a substantial oxygen consumption was observed after 250 days. OMP concentrations were not significantly affected by the microbial processes. A layer of calcium carbonate crystallites was observed on the POC layer. Some leaf fragments appeared to be persistant towards degradation and the carbon content relative to nitrogen and sulfur contents decreased within 250 days. The results demonstrate that trees at bank filtration sites might have a strong long-term impact on the subsurface redox conditions. © 2018 Elsevier Inc. All rights reserved.Veröffentlichung The challenge in preparing particle suspensions for aquatic microplastic research(2019) Eitzen, Lars; Paul, Sophia; Braun, Ulrike; Ruhl, Aki SebastianThe occurrence of small particles consisting of organic polymers, so-called microplastic (MP), in aquatic environments attracts increasing interest in both public and science. Recent sampling campaigns in surface waters revealed substantial numbers of particles in the size range from a few micrometers to a few millimeters. In order to validate sample preparation, identification and quantification and to investigate the behavior of MP particles and potential toxic effects on organisms, defined MP model particles are needed. Many studies use spherical compounds that probably behave differently compared to irregularly shaped MP found in environmental samples. However, preparation and handling of MP particles are challenging tasks and have been systematically investigated in the present study. Polystyrene (PS) as a commonly found polymer with a density slightly above that of water was selected as polymer type for milling and fractionation studies. A cryogenic ball mill proved to be practical and effective to produce particles in the size range from 1 to 200 Ìm. The yield of small particles increased with increasing pre-cooling and milling durations. Depending on the concentration and the size, PS particles do not completely disperse in water and particles partly creep vertically up along glass walls. Stabilized MP suspensions without use of surfactants that might harm organisms are needed for toxicological studies. The stabilization of PS particle suspensions with ozone treatment reduced the wall effect and increased the number of dispersed PS particles but increased the dissolved organic carbon concentration and changed the size distribution of the particles. © 2018 Elsevier Inc. All rights reserved.Veröffentlichung Entwicklung neuer Filtermaterialien zur Entfernung von Chromat(2018) Massa, Lukas; Höhne, A.; Bahr, Carsten; Ruhl, Aki Sebastian; Deutschland. Umweltbundesamt. Fachgebiet II.3.1 - Nationale und internationale Fortentwicklung der Trinkwasserhygiene; Trinkwasserressourcen