Person:
Bannick, Claus Gerhard

Profilbild
E-Mail-Adresse
Geburtsdatum
Forschungsvorhaben
Organisationseinheiten
Logo der Organisationseinheit
Organisationseinheit
Berufsbeschreibung
Nachname
Bannick
Vorname
Claus Gerhard
Name

Filter

2015 - 201982020 - 202312
Filter zurücksetzen

Einstellungen

Suchergebnisse

Gerade angezeigt 1 - 10 von 20
  • Vorschaubild nicht verfügbar
    Veröffentlichung
    Fast identification of microplastics in complex environmental samples by a thermal degradation method
    (2017) Dümichen, Erik; Bannick, Claus Gerhard; Eisentraut, Paul; Barthel, Anne-Kathrin
    In order to determine the relevance of microplastic particles in various environmental media, comprehensive investigations are needed. However, no analytical method exists for fast identification and quantification. At present, optical spectroscopy methods like IR and RAMAN imaging are used. Due to their time consuming procedures and uncertain extrapolation, reliable monitoring is difficult. For analyzing polymers Py-GC-MS is a standard method. However, due to a limited sample amount of about 0.5 mg it is not suited for analysis of complex sample mixtures like environmental samples. Therefore, we developed a new thermoanalytical method as a first step for identifying microplastics in environmental samples. A sample amount of about 20 mg, which assures the homogeneity of the sample, is subjected to complete thermal decomposition. The specific degradation products of the respective polymer are adsorbed on a solid-phase adsorber and subsequently analyzed by thermal desorption gas chromatography mass spectrometry. For certain identification, the specific degradation products for the respective polymer were selected first. Afterwards real environmental samples from the aquatic (three different rivers) and the terrestrial (bio gas plant) systems were screened for microplastics. Mainly polypropylene (PP), polyethylene (PE) and polystyrene (PS) were identified for the samples from the bio gas plant and PE and PS from the rivers. However, this was only the first step and quantification measurements will follow. © 2017 Elsevier Ltd.
  • Vorschaubild nicht verfügbar
    Veröffentlichung
    Analysis of polyethylene microplastics in environmental samples, using a thermal decomposition method
    (2015) Dümichen, Erik; Bannick, Claus Gerhard; Barthel, Anne-Kathrin; Braun, Ulrike; Brand, Kathrin; Jekel, Martin; Senz, Rainer
    Small polymer particles with a diameter of less than 5 mm called microplastics find their way into the environment from polymer debris and industrial production. Therefore a method is needed to identify and quantify microplastics in various environmental samples to generate reliable concentration values. Such concentration values, i.e. quantitative results, are necessary for an assessment of microplastic in environmental media. This was achieved by thermal extraction in thermogravimetric analysis (TGA), connected to a solid-phase adsorber. These adsorbers were subsequently analysed by thermal desorption gas chromatography mass spectrometry (TDS-GC-MS). In comparison to other chromatographic methods, like pyrolyse gas chromatography mass spectrometry (Py-GC-MS), the relatively high sample masses in TGA (about 200 times higher than used in Py-GC-MS) analysed here enable the measurement of complex matrices that are not homogenous on a small scale. Through the characteristic decomposition products known for every kind of polymer it is possible to identify and even to quantify polymer particles in various matrices. Polyethylene (PE), one of the most important representatives for microplastics, was chosen as an example for identification and quantification.Quelle: http://www.sciencedirect.com
  • Vorschaubild
    Veröffentlichung
    Bioabfallkomposte und -gärreste in der Landwirtschaft
    (2017) Bannick, Claus Gerhard; Claussen, Ulrich; Ehlers, Knut; Hermann, Tim; Weiss, Volker; Deutschland. Umweltbundesamt
    In mehr als 1.000 Kompostierungs- und Vergärungsanlagen werden in Deutschland getrennt gesammelte Bioabfälle behandelt, um die entstehenden Erzeugnisse (Komposte und Gärreste) anschließend als ŞDünger und Humuslieferant verwerten zu können. Der größte Anteil sind getrennt gesammelte ŞKüchen- und Gartenabfälle aus privaten Haushalten, aber auch aus der Park- und Landschaftspflege der Städte und Gemeinden. Ebenso gehören zu den Bioabfällen tierische und pflanzliche Abfälle aus der Lebensmittel erzeugenden und verarbeitenden Industrie sowie gewerbliche Bioabfälle wie abgelaufene Lebensmittel aus dem Handel und Speiseabfälle aus Restaurants und Kantinen. Quelle: Verlagsinformation
  • Vorschaubild nicht verfügbar
    Veröffentlichung
    Kunststoffe und Mikrokunststoffe in der Umwelt
    (2019) Bannick, Claus Gerhard; Braun, Ulrike
  • Vorschaubild nicht verfügbar
    Veröffentlichung
    Plastik in Böden: Einträge, Verhalten und Verbleib
    (2022) Bannick, Claus Gerhard; Bauerfeld, Katrin; Bednarz, Marius; Braun, Ulrike
  • Vorschaubild nicht verfügbar
    Veröffentlichung
    Occurrence of microplastics in the Danube River - a first screening
    (2021) Asenova, Mina; Bannick, Claus Gerhard; Bednarz, Marius; Kerndorff, Alexander; Obermaier, Nathan; Ricking, Mathias
    Plastics, and microplastics in particular, are still part of scientific and regulatory discussions. Their inputs from land ultimately end up in the oceans, where they remain for a long time. River systems represent an important path of entry into the oceans. The Danube is the second largest river in Europe and can therefore be an example for the occurrence of plastic in other large river systems. In JDS4 a comprehensive screening of microplastics was carried out over the entire course of the river. Sampling was performed by means of deploying sedimentation boxes into the river for 14 days; followed by thermo-analytical detection (TED-GC/MS) for determination of the total content of various plastic polymers in the collected suspended particulate matter samples. For the first time, a baseline of pollution by microplastics in the Danube River Basin has been established. In all samples almost, all analyzed polymers were detected and quantified, whereas there is no clear trend along the Danube with increasing or decreasing contents. The contents ranged between 0.05 - 22.24, 0.00 - 0.45, 0.00-1.03 and 0.00 3.32 for PE, PP, SBR and PS [(micro)g/mg] SPM, respectively. Quelle: A shared analysis of the Danube River : joint Danube survey 4 ; scientific report / Editors: Igor Liška [and five others]. - Vienna : International Commission for the Protection of the Danube River, 2021. - 1 Onlineresource (562 pages) : Illustrationen. - E-Book; Dateigröße / Dateiumfang: 44,09 MB. - ISBN 978-3-200-07450-7, Seite 487
  • Vorschaubild nicht verfügbar
    Veröffentlichung
    Garment ageing in a Laundry care process under household-like conditions
    (2023) Heller, Claudia; Altmann, Korinna; Bannick, Claus Gerhard; Braun, Ulrike; Kerndorff, Alexander
    This study reflects typical consumer textile washing behaviour while taking into account existing standards in the household appliance and garment industries. Two garments were washed repeatedly with artificial dirt and detergent 30 times. The collected washing water was separated using fractional filtration. Textile physical tests were used to follow property changes of the garments, the microplastic release is determined using thermoextraction/desorbtionâ€Ìgas chromatography/mass spectrometry and the total organic carbon was measured as a sum parameter for the organic bonded carbon. This article shows the importance of a reality-based approach when investigating microplastics of textile origin in the laundry care process. Deposits of detergent and dirt on the textiles were detected. The total mass of sieve residues was much higher than the release of synthetic polymers. The cotton content of the garments causes a much higher fibre release than synthetic fibres. Both will lead to false results by purely gravimetric analysis because nonpolymer fibres will be included microplastic mass. The results cannot be generalised only by the main polymer type, knowledge of the textile construction must be included for final evaluation. © 2023 Wiley-VCH GmbH.
  • Vorschaubild nicht verfügbar
    Veröffentlichung
    Identification and Quantification of Microplastic in Sewage Systems by TED-GC-MS
    (2019) Altmann, Korinna; Goedecke, Caroline; Bannick, Claus Gerhard
    The number of publications reporting the amount of microplastic (MP) all over the world increased rapidly. Methods used so far are very time consuming and not able to provide information on total contents. As harmonised sampling, sample preparation and analysis strategies are missing different studies can hardly be compared and quantitative data, including identification and mass contents of the polymers found, are missing. This leads to a lack of comprehensive understanding of MP occurrence, source and entry pathways into the environment. We developed a method, Thermal Extraction/Desorption-Gaschromatography-Massspectrometry, as a fast screening method for MP analysis. Solid residues of water samples are heated up to 600 C under a N2 atmosphere without any sample preparation. The collected decomposition gases are separated in a gas chromatography system and detected in a mass spectrometer. Mass contents of the identified polymers can be calculated. In this presentation we will show first results from the influent of the wastewater treatment plant Kaiserslautern (Germany) and its combined sewage system as possibly entry pathway. In order to determine the relevance of wastewater split streams analysis of grey water will be conducted. Samples are fractionally filtered by a sieve cascade with mesh sizes of 500, 100, 50 ÃŒm. Quelle: https://opus4.kobv.de/
  • Vorschaubild nicht verfügbar
    Veröffentlichung
    Development and testing of a fractionated filtration for sampling of microplastics in water
    (2019) Bannick, Claus Gerhard; Obermaier, Nathan; Ricking, Mathias; Schniegler, Sara; Szewzyk, Regine; Barthel, Anne-Kathrin
    A harmonization of sampling, sample preparation and detection is pivotal in order to obtain comparable data on microplastics (MP) in the environment. This paper develops and proposes a suitable sampling concept for waterbodies that considers different plastic specific properties and influencing factors in the environment. Both artificial water including defined MP fractions and the discharge of a wastewater treatment plant were used to verify the derived sampling procedure, sample preparation and the subsequent analysis of MP using thermal extraction-desorption gas chromatography - mass spectrometry (TED-GC-MS). A major finding of this paper is that an application of various particle size classes greatly improves the practical handling of the sampling equipment. Size classes also enable the TED-GC-MS to provide any data on the MP size distribution, a substantial sampling property affecting both the necessary sampling volume and the optimal sampling depth. In the artificial body of water with defined MP fractions, the recovery rates ranged from 80-110%, depending on the different MP types and MP size classes. In the wastewater discharge, we found both polyethylene and polystyrene in different size classes and quantities. © 2018 Elsevier Ltd. All rights reserved.
  • Vorschaubild nicht verfügbar
    Veröffentlichung
    Mikroplastik im Wasserkreislauf
    (Universitätsverlag der TU Berlin, 2020) Jekel, Martin; Anger, Philipp; Bannick, Claus Gerhard; Barthel, Anne-Kathrin; Grummt, Tamara; Kuckelkorn, Jochen; Obermaier, Nathan; Ruhl, Aki Sebastian; Strobel, Claudia; Technische Universität Berlin. Fachgebiet Wasserreinhaltung; Bundesanstalt für Materialforschung und -prüfung
    Das interdisziplinäre Forschungsprojekt MiWa widmete sich grundlegenden Fragestellungen zur Analytik und Wirkung von Mikroplastik-Partikeln im Wasserkreislauf. Es wurden Methoden der Umweltprobennahme, der Probenaufbereitung und verschiedene Detektionsverfahren zur Charakterisierung und Quantifizierung von Mikroplastik intensiv untersucht, miteinander verglichen und weiterentwickelt. Öko- und humantoxikologische Untersuchungen dienten dem Zweck, die potenziell von Mikroplastik ausgehende Gefährdung für die aquatische Umwelt und den Menschen zu analysieren und zu bewerten. Eine Harmonisierung und Standardisierung von Methoden der Probennahme, Probenaufbereitung und Mikroplastik-Detektion sind trotz der erheblichen Fortschritte derzeit nur teilweise möglich. Die ökotoxikologischen Studien zeigen zwar die Aufnahme von Mikroplastik-Partikeln durch einige Organismen, jedoch konnte bisher keine schädigende Wirkung nachgewiesen werden. Dabei wurden für eine Auswahl aquatischer Modellspezies sowohl Szenarien direkter als auch indirekter Exposition innerhalb einer Nahrungskette betrachtet. Interaktionen mit menschlichen Modellzellen wurden bislang nur bei Mikroplastik-Partikeln mit Größen weit unterhalb von 1 Ìm (also Nanoplastik) beobachtet. Eine umfassende Bewertung ist bislang nicht möglich. Quelle: https://depositonce.tu-berlin.de